Compression reference of soil structure evaluation with reconstituted clays at different initial water contents     

Ling-Ling Zeng  Zhen-Shun Hong  Yu-Jun Cui  Martin D. Liu 《Marine Georesources & Geotechnology》2018,36(7):759-767

  相似文献   

盾构隧道下穿管道施工引起的管-土相互作用研究     

可文海  管凌霄  刘东海  邓建林  李科  徐长节 《岩土力学》2020,41(1):221-228

采用Loganathan公式研究了盾构隧道下穿管道施工引起的地下管道处土体竖向位移，利用考虑土中剪力传递的Pasternak模型模拟管-土相互作用，运用修正Vlasov模型中的迭代流程计算出Pasternak模型的关键参数——弹性系数k与剪切系数gs。将计算结果与已有文献结果及工程监测数据进行对比，深入分析了迭代求解k、gs值的Pasternak模型与传统模型的计算差异，并进一步研究了土中剪力、管道与隧道的夹角、土体弹性模量及隧道半径的变化对管-土相互作用的影响。研究结果表明：迭代求解的k、gs值能提升Pasternak模型的精确度；土中剪力对管道竖向位移计算值的影响可达15.3%；随着管道与隧道夹角的减小，管道的竖向位移增大、弯矩减小；土体弹性模量与隧道半径的增大均会增加管道的竖向位移和弯矩。  相似文献   

Magnitude of latent heat in thermally loaded clays     

Sergio Samat  Laurent Brochard  Ioannis Stefanou 《国际地质力学数值与分析法杂志》2020,44(14):1926-1957

Temperature changes are known to induce specific couplings in clay, in particular, an anomalously high thermal pressurization in undrained conditions or a thermal compaction in drained conditions, both of which are potential threats for the mechanical stability and sealing capacity of the geomaterials. Thermodynamical analysis of those peculiar thermomechanical couplings points to a potentially important latent energy, which in turn could limit the temperature change upon heating or cooling. The direct measurement of latent energy developed during a laboratory geomechanical test is challenging. Instead, proper identification of thermal hardening in conventional experiments with temperature changes provides an alternative route to estimate latent energy. In this work, existing laboratory thermomechanical tests of clays are analyzed with a rigorous thermodynamic framework to quantify the magnitude of latent energy in thermomechanically loaded clays. A thermodynamically consistent constitutive model for fully saturated clays that combines two key features, (a) the temperature dependence of the blocked energy and (b) the framework of bounding plasticity, is proposed. The performance of the model is validated by reproducing results obtained in laboratory tests for Boom and Opalinus clays. The thermomechanical loads considered to validate the model performance were then used to estimate the percentage of work that remains latent in the clayey material during plastic yielding. We find that the magnitude of latent energy is quite significant, typically a few tens of percent of the total dissipated energy, and increases significantly with temperature. Accordingly, it is expected to play an important role in the thermomechanical response of clays.  相似文献   

GIS‐based modelling of soil erosion processes using the modified‐MMF (MMMF) model in a large watershed having vast agro‐climatological differences          下载免费PDF全文

Pratiksha Jain  RAAJ Ramsankaran 《地球表面变化过程与地形》2018,43(10):2064-2076

The present study demonstrates a spatially distributed application of a field‐scale annual soil loss model, the modified‐MMF (MMMF), to a large watershed using hydrological routing techniques, remote sensing data and geospatial technologies. In this study, the MMMF model is implemented after incorporating the corrections suggested in recent literature along with appropriate modifications of the model to suit the agro‐climatological conditions prevailing in most parts of India. Sensitivity analysis carried out through an Average Linear Sensitivity approach indicates that the model outputs are highly sensitive to soil moisture (MS), bulk density (BD), effective hydraulic depth (EHD), ground cover (GC) and settling velocity for clay (VS_c). During calibration and validation, the performance evaluation statistics are mostly in the range of very good to satisfactory for both runoff and soil loss at the watershed outlet. Even spatial validation of the results of intermediate processes in the water phase and the sediment phase, although qualitative, seems to be reasonable and rational. Furthermore, the soil erosion severity analysis for different land‐uses existing in the watershed indicates that about 90% of the watershed area, especially that occupied by agricultural lands, is vulnerable to the long‐term effects of soil erosion. Copyright © 2018 John Wiley & Sons, Ltd.  相似文献   

Bounding surface SANICLAY plasticity model for cyclic clay behavior     

Gaziz Seidalinov  Mahdi Taiebat 《国际地质力学数值与分析法杂志》2014,38(7):702-724

  相似文献   

黄原胶改性微米铁修复地下水中Cr(Ⅵ)污染的试验     

赵勇胜  李彧 《吉林大学学报(地球科学版)》2021,51(4):1224-1230

为了解决微米铁的重力沉降问题,提高微米铁修复地下水Cr（Ⅵ）污染的原位修复效果,本文利用黄原胶对微米铁进行改性,并通过沉降实验探究改性微米铁浆液的稳定性,同时选择Cr（Ⅵ）作为目标污染物,探究黄原胶改性微米铁去除地下水Cr（Ⅵ）污染的降解能力。实验结果显示：当黄原胶的投加质量浓度分别为0.0、1.0、1.5、2.0、2.5、3.0、6.0 g/L时,改性微米铁浆液的悬浮稳定性逐渐得到加强,在5 h沉降实验结束时,对应的相对分光光度值分别为0.05、0.25、0.46、0.57、0.65、0.73和0.87;黄原胶具有抑制微米铁吸附Cr（Ⅵ）的能力,其可促进Cr（Ⅵ）的还原,提高Cr（Ⅵ）的去除率;随着黄原胶投加质量浓度的增加,对应的Cr（Ⅵ）去除率分别为33.4%、41.2%、47.4%、51.1%、53.0%、63.9%和64.1%;6.0 g/L黄原胶改性的微米铁浆液具有最佳的悬浮稳定性,黄原胶的投加提高了微米铁的反应活性,但当黄原胶投加质量浓度超过3.0 g/L时,其对Cr（Ⅵ）的去除率没有显著提高;黄原胶投加质量浓度越大,黄原胶的缓冲作用就越明显。  相似文献   

大尺度平原城市精细汇水区分级划分研究     

王岩  范子贤  李成名  戴昭鑫  吴政 《测绘通报》2021,(7):117-120,125

在城市内涝模拟研究中,汇水区划分是十分重要的环节,同时对大尺度平原城市进行汇水区精细划分也是研究者共同研究的技术难点。针对现有基于DEM流向分析的划分方法存在的无法正确反映实际城市复杂地形和流向问题,本文提出了一种顾及地类和流向,适用于大尺度平原城市的精细汇水区分级划分方法。首先,从城市自然地形和主干河流出发,进行一级宏观尺度划分;然后,依据城市主次干道,干渠和管网实现二级中观尺度划分;最后,在二级划分的基础上,结合流向和地类做精细的三级子汇水区微观尺度划分。本文选取东营市30 km²核心主城区进行了验证分析,研究结果表明,划分结果跟实际地物类型和真实流向相吻合,该方法对于大尺度平原城市具有良好的适用性。  相似文献   

非均质地基中平面应变隧道开挖面稳定上限分析     

宋春霞  黄茂松  吕玺琳 《岩土力学》2011,32(9):2645-2650

非均质是软黏土地基中比较普遍的现象,而目前隧道开挖面稳定研究中比较成熟的理论主要是针对均质土体。因此,从塑性极限分析上限法的基本原理出发,采用平面应变隧道刚体平动破坏模式(多块体上限法),考虑软黏土地基的非均质性,推导了平面应变隧道极限支护压力关于隧道埋深、土体重度及土体强度的上限公式。通过与其他方法的比较分析,证明了极限分析方法在隧道开挖面稳定性方面的可行性;利用该方法的计算结果详细探讨了隧道开挖面稳定的影响因素;而且由计算结果可知,地基土的非均质性在影响隧道开挖面极限支护压力的同时,也影响着隧道开挖破坏面的位置和形状,为工程实践提供重要的理论依据。  相似文献   

An efficient focusing model for generation of freak waves   总被引：1，自引：1，他引：0  

LIU Zanqiang  ZHANG Ningchuan  YU Yuxiu 《海洋学报(英文版)》2011,30(6):19-26

Based on the Longuet-Higgins wave model theory, the previews studies have shown that freak waves can be generated in finite space and time successfully. However, as to generating high nonlinear freak waves, the simulation results will be unrealistic. Therefore, a modified phase modulation method for simulating high nonlinear freak waves was developed. The surface elevations of some wave components at certain time and place are positive by modulating the corresponding random initial phases, then the total surface elevation at the focused point is enhanced and furthermore a freak wave event is generated. The new method can not only make the freak wave occur at certain time and place, but also make the simulated wave surface time series satisfy statistical properties of the realistic sea state and keep identical with the target wave spectrum. This numerical approach is of good precision and high efficiency by the comparisons of the simulated freak waves and the recorded freak waves.  相似文献   

Experimental evaluation of shear strength behaviour of plastic and non-plastic silts     

A. Usmani  K.G. Sharma  A. Nanda 《Geomechanics and Geoengineering》2015,10(3):174-181

Silt is available in many parts of the world in combination with sands and clays. However, due to lack of clear understanding of its engineering behaviour, most of the time it is interpreted in terms of either sands or clays. Structures that are usually built on silty soils are designed to take into account design procedures developed for sandy or clayey soils. Presence of silts in combination with varying amount of sand and clays produces silt that is either plastic or non-plastic in nature. Silt is available in and around the Delhi region, in a majority mixture along with fine sands, which is non-plastic in nature. On the other hand silty deposits found in offshore Bombay High region are found in abundance along with significant amounts of clays and are termed as plastic silts. In this paper a comparison of the stress-strain behaviour of plastic and non-plastic silts is carried out under triaxial compression loading during both drained and undrained conditions. Two representative samples each from Delhi and Bombay High regions were considered for this comparison and results of stress-strain under four sets of confining pressure are discussed in detail. It is observed from this study that behaviour of silts is mainly dependent on the composition and structure of the resultant soil matrix. It is concluded from the results that shear strength parameters as well as volume change/pore pressure response of silty soils is dominated by the constituent soil present along with the silt. It is seen from the comparative behaviour of non-plastic and plastic silts that the presence of sand and clays has a governing effect on pore pressure development and the resultant friction angle. The study also corroborated that the nature of silt is transitional both in the case of plastic and non-plastic forms.  相似文献